Samsung Galaxy Light. Enable Downloading for Web Applications

Disconnecting a Paired Bluetooth Device
Disconnecting a paired device breaks the connection
between the device and your phone, but retains the
knowledge of the pairing. At a later point when you wish to
reconnect the device, there is no need to setup the
connection information again.
1. Verify your Bluetooth is active.
2. From the Bluetooth settings page, tap the previously
paired device (from the bottom of the page).
3. Tap OK to confirm disconnection.
Note: Disconnections are manually done but often occur
automatically if the paired device goes out of range of
your phone or it is powered off.
Deleting a Paired Bluetooth Device
Deleting a device from your list removes its “connection
record” and upon reconnection would require that you
re-enter all the previous pairing information.
1. Verify Bluetooth is active.
2. From the Bluetooth settings page, tap
➔ Unpair to delete the paired device.
204
(Settings)
Enable Downloading for Web
Applications
Important! Before you can download a web application you
must insert an SD into the phone and enable the
Unknown sources feature (enables downloading).
For more information, refer to “Installing the
microSD Memory Card” on page 10.
1. From the Home screen, press
and then tap
Settings ➔
(More tab) ➔ Security ➔
Unknown sources check box.
2. Tap OK to allow install of non-Play Store applications.
Tap again to remove the check mark and disable the
installation of non-Play Store applications.
Warning! Not all web applications are safe to download. In
order to protect your phone and data, use the Play
Store to install web applications. For more
information, refer to “Downloading a New Google
Application” on page 187.