Comments
Description
Transcript
Samsung Galaxy Light. WiFi
Wi-Fi About Wi-Fi Wi-Fi (short for "wireless fidelity") is a term used for certain types of Wireless Local Area Networks (WLAN). Wi-Fi communication requires access to an existing and accessible Wireless Access Point (WAP). These WAPs can either be Open (unsecured) as within most Hot Spots, or Secured (requiring knowledge of the Router name and password). Note: After you complete a connection to an active Wi-Fi network, the Wi-Fi Calling feature will automatically be enabled. Note: For additional information on WPS Connections, refer to "WPS Push Button" on page 216 and "WPS PIN Entry" on page 217. Activating Wi-Fi By default, your device’s Wi-Fi feature is turned off (deactivated). Activating Wi-Fi allows your device to discover and connect to compatible in-range WAPs (Wireless Access Points). 1. From the Home screen, press and then tap Settings ➔ (Connections tab). 2. In a single motion touch and slide the Wi-Fi slider to the right to turn it on. The device scans for available in-range wireless networks and displays them under Wi-Fi networks on the same screen. Connecting to a Wi-Fi Network 1. From the Home screen, press and then tap Settings ➔ Connections tab ➔ Wi-Fi. The network names and security settings (Open network or Secured with WEP) of detected Wi-Fi networks display in the Wi-Fi networks section. 2. Tap the network you wish to connect to. Note: When you select an open network you are automatically connected. 206 3. Enter a wireless password (if necessary). 4. Tap Connect. Wi-Fi Status Indicators The following icons indicate the Wi-Fi connection status: Manually Add a New Network Connection 1. From the Wi-Fi network screen, tap Add Wi-Fi network. 2. Enter the Network SSID (the name of your Wireless Access Point). Displays when Wi-Fi is connected, active, and communicating with a Wireless Access Point (WAP). 3. Tap the Security field and select a security option. This must match the current security setting on your target WAP. Displays when Wi-Fi is active and there is an available open wireless network. 4. Enter your WAP’s password if the WAP is secure. Displays when Wi-Fi Direct is active and communicating Displays when Wi-Fi is being used as a Mobile HotSpot feature is active and communicating. 5. Tap Connect to store the new information and connect to the target WAP. Note: No prompt to enter the WAP key displays if this is the second time to connect to a previously accessed or secured wireless network. The WAP key is required when the device is reset using factory default settings. Connections 207